Firepro B359 fire hatches are designed to sit flush with the ceiling surface leaving only a narrow opening joint around the face with no protruding hinges. The hatch is secured by a locking key. FRR 1 hour.

Firepro B355 Floor Fire Hatch is designed for lift motor rooms and similar situations where a very large access space is required from above a fire compartment. B355 is designed for use in concrete floors.

Centabuild H101 Access Hatch provides an economical answer to access requirements through non-fire rated walls and ceilings. The 560mm x 560mm size hatch allows head & shoulder access into ceiling voids. Smaller sizes are for situations where hand access is required through non fire-rated walls and ceilings.

Centabuild H105, H106 for installations where larger hatches or noise dampening is required, and/or where security is important. The hatches can be installed during construction or after the ceiling is in-place. H106 hatches are designed to fit flush with the ceiling leaving only a narrow opening joint around the edges with no visible hinges. The hatch is secured with a lock which can be individually or identically keyed. Alternatively a universal lock option is available on most sizes. The hatch panel is made from board with an STC of 29. Sound dampening seals are provided around the joint of the panel and the frame. An integral plasterers angle is standard with the complete range of H106.

Firepro B350. Provides access through plaster board or concrete fire rated walls. Are simple to Install. Available in a large range of sizes. The B350 and B351 have been fire tested to AS/NZ 1530-4:1997 and BS476-22:1987. B350 is tested for 120 Minute integrity and 114 minute insulation (-/120/90) and B351 for -/60/60, when used in walls of appropriate fire rating.